MANUALS > Orders > Orders Switches > SELPNCTRLREMOVEREACH - Automatically Select P/N Control on a R/O if Scheduled Removals are Reached

SELPNCTRLREMOVEREACH - Automatically Select P/N Control on a R/O if Scheduled Removals are Reached

Automatically Select P/N Control on a R/O if Scheduled Removals are Reached

Affected Window: w_ro_order_detail_eu

Switch Set to Yes:

When set to Yes, P/N Controls for Part Number Serial Numbers are automatically selected on a Repair Order if the P/N Control's amount of Scheduled Removals are reached.

Notice that the following P/N Control has a Removal Schedule of '2.'

From the P/N Inventory Control window of the Inventory Transaction, notice that this P/N S/N (with the above P/N Control) has been removed '1' time, as indicated by the Actual Removal field.

The P/N S/N is then remove for a second time from an aircraft.

Notice now that the Actual Removals has reached the Scheduled Removals limit.

This P/N S/N is then placed on a Repair Order.

From the Repair Order Detail, Control tab, notice that the above P/N Control has been automatically selected because of its Removal limits.

Switch Set to No:

When set to No, P/N Controls for Part Number Serial Numbers are not selected on a R/O if the P/N Control's amount of Scheduled Removals are reached.

The same P/N S/N from the above example was removed from the R/O.

Then that P/N S/N was re-inserted into the R/O.

From the Repair Order Detail, Control tab, notice that the P/N Control has not been automatically selected, regardless of its Removal limits.