PLANNING CONTROL > Due List, via Planning Control > Planning Results, via Due List > Part Status Indicator Button, via Due List

Part Status Indicator Button, via Due List

The Part Status Indicator button displays parts available in inventory, on order, or reserved for a particular location (partial/all/none).

Note: Planning will always show that it requires the same part as if it were being replaced for P/N Controls.

Note: Parts will not be reserved for P/N Controls unless a Task Card is attached to that part.

Select the Part Status Indicator button to open the Parts/Tools Table window. All available parts and related information is displayed in this window.

The following information/options are available in this window:
_____________________________________________________________________________________

Part Status Indicator button

The green status button displays that all spares required are available in inventory.

Part Status Indicator button

The yellow status button displays that some, but not all spares are available in inventory.

Part Status Indicator button

The red status button displays that no spares are available in inventory.

Create Requisition button

Select to create a requisition for all required parts.

_____________________________________________________________________________________

Part Requirements:

The Part Status Indicator button appears when material requirements exists for the E/C or P/N Control Task Card or Defect Report.

Notice a material requirement exist for this defect through the Defect Report window in the P/N Requirement List tab. The required P/N quantity is available so the Part Status Indicator button displays the green indicator.

When Defects are queried through Planning Control via the Fleet Due List tab the Part Status Indicator button also displays the green indicator.