Share
Print
|
|
|
|
|
Shop Work Order Detail
The Shop Work Order allows the assembly of work packs to carry out work on the components. Shop Work Orders can also be for Third Party work where the operator's company is carrying out work for an outside company and charging them.
The Shop Work Order contains several elements. These elements will be used upon saving the Shop Work Order to provide financial analysis and also to update the technical information for the aircraft or component. The following elements are available:
Engineering Controls - Shop E/Cs, P/N E/Cs, or P/N Controls (TSO, LL, TSR).
Task Cards - Which can be copied into the Shop Work Order as a result of adding a PN E/C, or added individually as required.
Shop Task Cards - (Which can be copied into the Shop Order as a result of adding the Shop EC).
Non-Routine Cards - (Which can be created while work is performed and further inspections are required in the Shops).
Costs - can be added to the Shop Work Order in the form of materials used and additional work costs booked to the Shop Work Order (such as repair and exchange costs, or service orders).
The following tabs and buttons are available at the detail level.
W/O Shop Detail Tabs |
W/O Shop Detail Buttons |
|---|---|
Print Functions Sub-Functions
|
Save button
Delete button
Release For Authorization button
Reset button
W/O Audit button
Capacity Planner button
Acknowledgment button
Bid Sheet button
For information on the options in the initial level, refer to Shop Work Orders.
Additional functionality can be utilized with the Shop Work Order, Man Hours Scheduling and Reservation.
Share
Print
|
©1997-2024 Trax USA Corp. All rights reserved. This manual may not be copied, photocopied, reproduced, translated, or converted to any electronic or machine-readable form, in whole or in part, without prior written approval from Trax USA Corp. |
 |