Settings Module

Location Site, General Tab

8.1

Capability Area - The Capability Area identifies where a maintenance task can be accomplished in association with the customer's internal capabilities (e.g., a particular E/C can only be accomplished during a heavy maintenance visit at a heavy maintenance capable Site). The Capability Area can be assigned for E/Cs, P/N Controls, and Defect Reports. However, a maintenance task with any Capability Area can be scheduled on Work Orders at Sites that have their Capability Area set to 'ALL'.

Location Site Configuration Effectivity Button, via Location Site Configuration

8.1

Tech-CTL - The Tech-CTL drop-down defines a part's Tech Control (e.g., APU, Engine, Landing Gear, Module, Disk, Recorder, None, etc).

Note: The Tech-CTL field is only available for Shop sites.

Location Site Configuration, General Tab

8.1

Capacity radio button - The following functionality has been added:

Tech-CTL - The Tech-CTL drop-down defines a part's Tech Control (e.g., APU, Engine, Landing Gear, Module, Disk, Recorder, None, etc).

Note: The Tech-CTL field is only available for Shop sites.

Capacity Qty - The following functionality has been added:

Note: The Capacity Qty for a Shop site can differ based on the Tech-CTL selected (e.g., the site may accommodate 2 engines whereas the same site could fit 4 APUs).

Capability radio button

Capability Area - The following functionality has been added:

Note: The Capability Area field is available for Shop sites.

Check Type radio button - The following functionality has been added:

Note: The Check Type radio button is available for Shop sites.

P/N Master, Inventory Tab

8.1

Slang Term - The Slang Term field is used to associate key words or common terminology with a tool. The tool can then be searched for using the Slang Term in the Tools Inventory window. This field is only available when the Tool Control checkbox is selected.

Site Configurations Button, via Location Site

8.1

Note: The Site Configurations button is available for Shop sites.

Site Button, via Location Master

8.1

Note: The Site Configurations and Site Inactive buttons only appear when the Production or Shop radio button is selected in the Location Site window.

Site Inactive Schedule Button, via Location Site

8.1

Note: The Site Inactive Schedule button is available for Shop sites.