Share
Print
|
|
|
|
|
INCASSEM - Display Warning When Closing Last T/C With An Incomplete Assembly
Display Warning When Closing Last T/C With An Incomplete Assembly
Affected Window: w_wo_task_card_update
Setup:
The following NHA has an incomplete assembly.
From the P/N Explorer, we can see that this is indeed an incomplete assembly.
Switch Set to Yes:
When set to Yes, the system will general a soft warning when closing the last Task Card on a Shop Work Order if the NHA is an incomplete assembly.
From the W/O Task Card window, close one of the two Task Cards against the Work Order.
The following Task Card is now closed. Close the second Task Card.
When the user attempts to close the last Task Card against the Work Order, the system generates the following soft warning.
Switch Set to No:
When set to No, the system will not generate a warning when the user attempts to close the last Task Card against a Work Order on a Shop Work Order if the NHA is an incomplete assembly.
Two Task Cards are associated to the following Work Order. The following Task Card is now closed. Close the second Task Card.
Close the second Task Card.
The system does not generate a soft warning to advise the user that the part number on the Work Order is an incomplete assembly and both Task Cards are now closed.
Share
Print
|
©1997-2024 Trax USA Corp. All rights reserved. This manual may not be copied, photocopied, reproduced, translated, or converted to any electronic or machine-readable form, in whole or in part, without prior written approval from Trax USA Corp. |
 |