Share
Print
|
|
|
|
|
GSE Initial Template Load
The GSE Initial Template Load option is only used when a new GSE is added to the system and the template function is selected.
This option will allow you to enter serial numbers for parts and positions on the GSE following a 'Template' load (either a new GSE created on the system, or a retrospective template creation).
The system has the P/N and Position. The data required is the Serial number and any Time Control or assembly information.
Data can be 'saved as you go' so that some data can be entered and saved; and the remaining data can be entered at a later time.
However the parts will not show on the GSE until the template is completed.
For more information, refer to the GSE Initial Template Load, General Tab and Importing Part Numbers and Serial Numbers.
Share
Print
|
©1997-2024 Trax USA Corp. All rights reserved. This manual may not be copied, photocopied, reproduced, translated, or converted to any electronic or machine-readable form, in whole or in part, without prior written approval from Trax USA Corp. |
 |